Acrylic (PMMA) door for shelving
Tell us the opening you want to cover and we calculate the panel. It is held by four printed guides that grip the shelf edges, and it comes out by lifting it: no hinges, no magnets and not a single hole drilled in the furniture.
The panel to be cut: 335 × 325 mm
The panel height is 10 mm less than the opening height, and that isn't a mistake: that travel is what lets you remove it by lifting. A 7.6 mm gap remains above it.
- Protective film on both sides until delivery
- ±0.5 mm cutting tolerance
- Glossy laser-cut edge, no further finishing
- Rigid packaging with corner protectors
2 warnings about this quote
We don't have that sheet in stock: we order it from our supplier and add 4 working days to the lead time.
Por encima de la puerta queda una ranura de 7.6 mm: es el recorrido que permite sacarla levantándola.
The opening you want to cover
What you want to close
Where the panel runs
Measure the clear opening
Width from side to side. Height from the top face of the lower shelf to the underside of the upper shelf.
The panel to be cut: 335 × 325 mm
The usable bed is 1,000 × 600 mm. For a larger opening, we make it as two panels: write to us.
Material
The handle
The printed parts
Units
Lead time
Notes for the workshop
We don't have that sheet in stock: we order it from our supplier and add 4 working days to the lead time.
Por encima de la puerta queda una ranura de 7.6 mm: es el recorrido que permite sacarla levantándola.
- Subtotal (1 ud.)
- €9.55
- IVA (21 %)
- €2.01
- Total incl. VAT
- €11.56
What makes up the price?
- Material
- €7.64
- Laser cutting
- €1.33
- Handling and inspection
- €0.58
- Machine setup
- €0.00
- Price per unit
- €9.55
Amounts per unit and excluding VAT. Setup is split across the parts in the order: the more you order, the less setup cost falls on each one.
Save or share
Made to order (+4 days): 3 mm silver
Estimated delivery in 7 working days
€11.56
€9.55 excluding VAT